In case of error, you can fully reinitialize your modem by clicking to button below.

Placement of the Router to Optimize Wireless Connectivity

The operating distance or range of your wireless connection can vary significantly based on the physical placement of the router. For best results, place your router:

• Near the center of the area in which your PCs will operate,
• In an elevated location such as a high shelf,
• Away from potential sources of interference, such as PCs, microwaves, and cordless phones,
• Away from large metal surfaces.
• Vertical position.

Note: Failure to follow these guidelines can result in significant performance degradation or inability to wirelessly connect to the router.

 

Wireless Access Point

Enable Wireless Router Radio:

The Wireless Router Radio of this router can be enabled or disabled to allow wireless access. The wireless icon on the front of the router will also display the current status of the Wireless Router Radio to let you know if it is disabled or enabled.

If Enabled, wireless stations will be able to access the Internet.
If Disabled, wireless stations will not be able to access the Internet.

Enable SSID Broadcast

If Enabled, the SSID will broadcast its name to all Wireless Stations. Stations which have no SSID (or a "null" value) can then adopt the correct SSID for connections to this Access Point.

 

Wireless Network

Name (SSID)

Enter a value of up to 32 alphanumeric characters. The same Name(SSID) must be assigned to all wireless devices in your network. We strongly recommends that you change your networks Name(SSID) to a different value. This value is also case-sensitive.

Channel

This field determines which operating frequency will be used. It should not be necessary to change the wireless channel unless you notice interference problems with another nearby access point.

 

Security Encryption (WPA-PSK/WPA2-PSK)

Pre-Shared Key

Enter a word or group of printable characters in the Pre-Shared Key box. The Pre-Shared Key must be 8 to 63 characters in length. The 256 Bit key used for encryption is generated from this Pre-Shared Key.

WPA/WPA2 Enterprise

Primary Radius Server IP Address

This field is required. Enter the IP address of the Radius Server on either WAN side or LAN side.

Radius Port

Enter the port number used for connections to the Radius Server.

Shared Key

Enter the desired value for the Shared Key. This must match the value used on the Radius server.

Click Apply to have your changes take effect.

 

Wi-Fi Access List

By default, any wireless PC that is configured with the correct SSID will be allowed access to your wireless network. For increased security, you can restrict access to the wireless network to only allow specific PCs based on their MAC addresses. Click the Setup Access List button to set the Wireless Access List menu.